Petrol safety warnings, Unpacking and assembly, Unpack cultivator – Powerplus POWXG7203 CULTIVATOR 148CC EN User Manual
Page 6: Assembly, Install the rotor blades, Install the depth skid and wheel bracket, Install the upper handle, Operating instructions, Pre-start inspection

POWXG7203
EN
Copyright © 2012 VARO
P a g e
| 6
www.varo.com
6 PETROL SAFETY WARNINGS
WARNING: Use extra care when handling fuels. They are inflammable and
the vapours are potentially explosive. The following points must be
observed.
Use only an approved container.
Never remove the fuel cap or add fuel when the engine is running. Allow engine exhaust
components to cool before refuelling.
Do not smoke.
Never refuel the machine indoors.
Never store the machine or fuel containers in places where there is a naked flame, such
as a water heater.
If fuel is spilt, do not attempt to start the power source before moving the machine away
from the spillage area.
Always replace and securely tighten the fuel cap after refuelling.
Whenever the tank is drained, this should be done outdoors.
7 UNPACKING AND ASSEMBLY
7.1
Unpack cultivator
Carefully lift the cultivator out of the box, remove any packing material and cut any ties holding
the handlebar pieces to the cultivator assembly.
7.2
Assembly
7.2.1
Install the rotor blades
Fit the two identical rotor blades to the gear shaft with the columniform pin, which is locked by
a cotter pin. (Fig. 1)
7.2.2
Install the depth skid and wheel bracket
Fit the depth skid and wheel bracket using the two columniform pin and cotter pin supplied.
(Fig. 2)
7.2.3
Install the upper handle
Fit the upper handle using the plastic adjusting screws. Note that these are marked with a
pivot point, which must face each other for the handle to function correctly. (Fig. 3)
8 OPERATING INSTRUCTIONS
8.1
Pre-Start Inspection
Make sure all safety guards are in place and all nuts and bolts are secure.
Check oil level in engine crankcase.
Important! Engine is shipped from the factory without oil. You must add
engine oil before starting engine.
Inspect air filter for cleanliness.
Check the fuel supply. Do not fill gas tank completely full, allow space for fuel to expand.
Be sure spark plug wire is attached and spark plug is tightened securely.