Powerplus POWX1345 MULTI-USE TOOL 300W EN - Manual (Page 6)

POWX1345
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
8.2 Speed adjusting (Fig. 5)
The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and
the "6" position indicates the highest speed, you can adjust different speed by turning the
speed control dial (3) from "1" to "6" position. The operator may have to vary the speed to
optimize working efficiency.
8.3 Application tips
8.3.1 Selecting the Application Tool/Accessory
Accessory Material
Plunge cut saw blade wood
Wooden materials, plastic,
gypsum and other soft materials.
Segment saw blade with recess
Wooden materials and plastic.
Shovel blade
Wood, paint, carpet adhesive,
silicone and other elastic
materials.
Base plate for sanding
Depends on sanding sheet
8.3.2 Sawing
Use undamaged faultless saw blades only. Deformed, blunt saw blades or
saw blades that are otherwise damaged can break.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with saw blades in wood, particle board, building materials, etc., check these
for foreign objects such as nails, screws, or similar. If required, remove foreign objects or use
saw blades for metal.