beautypg.com

4 how to use, 5 technical data – Powerplus POWXQ53600T STAND TABLE SAW EN User Manual

Page 2

background image

POWXQ53600T

EN

Copyright © 2013 VARO

P a g e

| 2

www.varo.com

Note: At this time, beware that a bearing unit will not come off from the bolt
top. If it comes off by mistake and comes apart, reassemble it with each
groove in two plates of the bearing unit facing the bearing balls and return
it to the original position on the bolt. (Fig. 3, 4)

4.

Align the table-raising/lowering bolt with the nut by adjusting the position of the table-
raising/lowering bolt so that it can be screwed in the preinstalled nut on the stand. (Fig. 5)

5.

Push the leg in the direction of arrow and screw in the table-raising/lowering bolt by
turning the table-raising/lowering wheel-handle counterclockwise while pushing it in that
way. (Fig. 6, 7)

6.

When the table-raising/lowering bolt top comes out of the surface of the nut, screw in the
bolt that was removed in No.3 above using the hex wrench. (Fig. 8)

7.

Insert two ends of the carrying handle with its gripping part facing upward into the holes
of the stand. (Fig. 9)

8.

Insert the bolt through the hole in the table and the groove in the carrying-handle and
then tighten the nut and bolt provided with the stand using two wrenches so that the
carrying-handle is movable. (Fig. 10)

9.

Remove the nut and washers (bigger ones) from the tire wheel using two wrenches. Also,
remove the bolt and washers (smaller ones) using the hex wrench. Use the same
procedure as the above for the other tire wheel. Turn the stand up side down and
assemble the tire wheels on the outside surface of the legs so that the locking pedal
faces the inside of the stand. (Fig. 11, 12). Use two wrenches to secure the bolts,
washers and nuts, that have been removed earlier, to

assemble the axis. Tighten firmly.

Also, tighten bolt and washers, that have been removed earlier, to lock

the tire wheel

plate.

4 HOW TO USE

 When securing table saw on the table saw stand, holes on your tool base match holes in

the stand. Then tighten hex bolts (4 positions) securely. (Fig. 13)

 Place the table saw stand on a level location. When setting up the table saw stand in the

upright position, turn the handle clockwise. (Fig. 14)

 Adjust the levelness of the table saw stand by rotating the foot, and then secure the table

saw stand by turning the nut. (Fig. 15)

 Secure the foot of stand to the stable and level surface using holes in the fix plates with

two hex bolts. (Fig. 16)

 To fold the table saw stand, turn the handle counterclockwise. (Fig. 17)

5 TECHNICAL DATA

Type

POWXQ53600T

Max. height

570mm

Table size

710mm x 540mm