Powerplus POWAIR0806 PNEUMATIC STAPLER/NAILER EN - Manual (Page 5)

POWAIR0806 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
 Air-operated tools must be inspected periodically, and worn or broken parts must be
replaced to keep the tool operating safely and efficiently. Check and change all worn or
damaged O-ring, Seals, etc. Tight all the screws and caps in case personal injury.
 Make regular inspection for free movement of trigger, Spring and safety mechanism to
assure safe system is complete and functional: no loose and missing parts, no building
or stocking parts.
 Keep magazine and nose of tool clean and free of any dirt lint or abrasive particles.
 When temperatures are below freezing, tools should be kept warm by any convenient,
safe method.
9 TECHNICAL DATA
Model POWAIR0806
Activation mode Single sequential action
Max. allowable pressure 120PSI(8.3 bar)
Operating pressure 60-100PSI(4-7bar)
Air inlet size ¼”
Avg. air consumption 65l/min(2.29cfm)
Recommended lubricant White mineral oil
Nail capacity 100pcs
10 NOISE
Noise emission values measured according to relevant standard. (K=2.5)
Acoustic pressure level LpA 89 dB(A)
Acoustic power level LwA 102 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) : 1.9 m/s² K= 0.5 m/s²
11 TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTIONS
Air leak
near top of tool or in
trigger area O-ring in trigger valve is
damaged. Check and replace O-ring.
Trigger valve head are
damage. Check and replace.
Trigger valve stem, seal or
O-ring are damaged. Check and replace trigger
valve stem, seal or O-ring
Air leak near bottom of
tool. Loose screws. Tighten screws.
Worn or damaged O-rings or
bumper. Check and replace O-rings
or bumper.
Air leak between body Loose screws. Tighten screw.