Powerplus POWAIR0805 PNEUMATIC MULTI-USE TOOL EN - Manual (Page 6)

POWAIR0805 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
In the event that it becomes necessary to store the tool for an extended period of time
(overnight, weekend, etc.), it should receive a generous amount of lubrication at that time.
The tool should be run for approximately 30 seconds to ensure oil has been evenly
distributed throughout the tool. The tool should be stored in a clean and dry environment.

It is most important that the tool be properly lubricated by keeping the air line
lubricator filled and correctly adjusted. Without proper lubrication the tool will not work
properly and parts will wear prematurely.
 Use the proper lubricant in the air line lubricator. The lubricator should be of low air
flow or changing air flow type, and should be kept filled to the correct level. Use only
recommended lubricants, specially made for pneumatic applications. Substitutes may
harm the rubber compounds in the tools, O-rings and other rubber parts.
8 IMPORTANT!!!
If no filter/ pressure regulator/ lubricator is installed in the compressed air system, then
pneumatic tools must be lubricated with 2 to 6 drops of oil at least once a day or after
every two hours of use. This must be done directly along the male coupler or the screw
(OIL) provided for the purpose on the side of the tool’s housing.
Automatic lubrication is also possible using the supplied mini oiler that you have to install
between the threaded connector of the tool and the male coupler. Make sure that the oiler
is always filled with suitable oil.
Fig. 1
1.
Tool
2. Quick connector
3. Quick coupler
4. Air hose
5. Quick connector
6. Quick coupler
7. Lubricator
8. Regulator (0-8.5 bar)
9. Filter
10. Cut-off valve
11. Air compressor
9 LOADING AND OPERATION
9.1 Installing accessories (Fig. 2)
ATTENTION! Always remove the hose leading to the compressor first
before changing accessories.
Select the accessory suitable for the job.

Insert the selected tool into the provided connection of the compressed air multitool.
You may adjust the accessory to the desired alignment in 30° increments using the
setting pins.

First place the washer onto the accessory and then place the spring ring over it.
 Now take the Allen screw and tighten using the included Allen key. Use the counter
wrench to fix the appliance while tightening the Allen screw.
9.2 Switching on/off
Verify the equipment is correctly connected and the hose properly seated.