Powerplus POWAIR0311 PNEUMATIC STAPLER/NAILER EN - Manual (Page 6)

POWAIR0311 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 When temperatures are below freezing, tools should be kept warm by any convenient,
safe method.
9 TECHNICAL DATA
Model POWAIR0311
Activation mode Single sequential action
Max. allowable pressure 120PSI(8.3 bar)
Operating pressure 60-100PSI(4-7bar)
Air inlet size ¼”
Avg. air consumption 78.68l/min(2.78cfm)
Recommended lubricant White mineral oil
Nail capacity 100pcs
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
87 dB(A)
Acoustic power level LwA 100 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) 2.9 m/s² K = 0.02 m/s²
11 TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTIONS
Air leak
near top of tool or in
trigger area O-ring in trigger valve is
damaged. Check and replace O-ring.
Trigger valve head are
damage. Check and replace.
Trigger valve stem, seal or
O-ring are damaged. Check and replace trigger
valve stem, seal or O-ring
Air leak near bottom of
tool. Loose screws. Tighten screws.
Worn or damaged O-rings or
bumper. Check and replace O-rings
or bumper.
Air leak between body
and cylinder cap. Loose screws. Tighten screw.
Worn or damaged O-rings or
seals. Check and replace O-rings
or bumper.
Blade driving fastener
too deep. Worn bumper. Replace bumper.
Air pressure is too high. Adjust the air pressure.
Tool does not operate
well: can not drive Inadequate air supply. Verify adequate air supply.
Inadequate lubrication. Place 2 or 6 drops of oil into