Excell Precision XC2600 - Manual (Page 16)

16- ENG A20116
STORAGE
ENGINE
Consult the Engine Owners Manual for
the man u fac tur er's recommendations
for storage.
PUMP
T h e m a n u f a c t u re r re c o m m e n d s
using a pump protector/winterizer,
such as DP80 when storing the
unit for more than 30 days and/or
when freezing temperatures are
expected. DP80 is availabe at the
store where the pressure washer
was purchased. If a pump protector/
winterizer is not available, RV antifreeze
needs to be run through the pump as
outlined in the steps below.
NOTE: Using a pump protector/
winterizer or RV antifreeze is to provide
proper lubrication to the internal seals
of the pump regardless of temperature
or environment.
1. Obtain a funnel, 6 oz. (170 mL)
of RV antifreeze and 16–36"
(40– 91cm) of garden hose with a
male hose connector attached to
one end.
R i s k o f p ro p e r t y
damage. Use only
RV antifreeze. Any other an ti freeze is
corrosive and can damage pump.
2. Disconnect spark plug wire.
3. Connect length of garden hose to
water inlet of pump.
4. Add RV antifreeze to hose as
shown.
5. Pull engine starter rope slowly
several times until an ti freeze
comes out of high-pressure hose
con nec tion of pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.
PRESSURE WASHER
1. Drain all water from high pressure
hose, coil it and store it in cradle
of the pressure washer handle.
2. Drain all water from spray gun
and wand by holding spray gun
in a vertical position with nozzle
end pointing down and squeezing
trigger. Store in gun holder.
3. Store chemical hose so it is
protected from dam age.
4. If space is needed, remove
handles and replace as shown.