beautypg.com

Electrolux U312940. EFC70710 User Manual

Page 20

background image

20 electrolux

INSTALLING THE COOKER HOOD

EN

Fitting the Wall Brackets

Wall marking:
• Draw a vertical line on the supporting

wall up to the ceiling, or as high as
practical, at the centre of the area in
which the hood will be installed.

• Draw a horizontal line at 650 mm

above the hob.

• Place bracket 7.2.1 on the wall as

shown about 1-2 mm from the ceiling
or upper limit aligning the centre
(notch) with the vertical reference line.

• Mark the wall at the centres of the

holes in the bracket.

• Place bracket 7.2.1 on the wall as

shown at X mm below the fi rst bracket
(X = height of the upper chimney
section supplied), aligning the centre
(notch) with the vertical line.

• Mark the wall at the centres of the

holes in the bracket.

• Mark a reference point as indicated

at 116 mm from the vertical reference
line and 306 mm above the horizontal
reference line.

11

12a

306

X

116

1÷2

116

650 min.

7.2.1

• Repeat this operation on the other

side.

• Drill ø 8 mm holes at all the centre

points marked.

• Insert the wall plugs (not supplied) in

the holes.

• Fix the lower bracket 7.2.1 using the

two screws (not supplied).

• Fix the upper bracket 7.2.1 and the air

outlet connection support 7.3 together
using the two screws (not supplied).

• Insert the two screws (not supplied)

supplied in the hood body fi xing holes,
leaving a gap of 5-6 mm between the
wall and the head of the screw.

Note: If the hood is to be installed
onto a hollow construction or
plaster or partition board wall
then special fi xing screws will be
required (not supplied).