Excell Precision XR2625 - Manual (Page 16)

16- ENG A14687
3. Connect length of garden hose
to water inlet of pump.
4. Add RV antifreeze or windshield
washer fluid to hose as shown.
5. Pull engine starter rope slowly
several times until antifreeze/
washer fluid comes out of high-
pressure hose con nec tion of
pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.
HOW TO CLEAN THE WATER
INLET FILTER
This screen fi lter should be checked
periodically and cleaned if necessary.
1. Remove
fi lter by
grasping end
and removing
it from water
inlet of pump
as shown. Filter Screen
STORAGE
ENGINE
Consult the Engine Owners
Manual for the man u fac tur er's
recommendations for storage.
PUMP
The manufacturer recommends using
a pump protector/winterizer, such as
DP80, when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. If a pump
protector/winterizer is not available, RV
antifreeze or windshield washer fluid
needs to be run through the pump as
outlined in the steps below.
NOTE: Using a pump protector/
winterizer, RV antifreeze or windshield
washer fluid is to provide proper
lubrication to the internal seals of the
pump regardless of temperature or
environment.
1. Obtain a funnel, 6 oz. of RV
antifreeze or windshield washer
fluid, and 16–36" of garden hose
with a male hose connector
attached to one end.
Risk of property
damage. Use only
RV antifreeze. Any other an ti freeze
is corrosive and can damage pump.
2. Disconnect spark plug wire.
2. Clean fi lter by fl ushing it with
water on both sides.
3. Re-insert fi lter into water inlet of
pump. NOTE: Cone side faces out.
NOTE: Do not operate pressure
washer without fi lter properly installed.