Description – Echo PAS Rapid Loader User Manual

Page 6

P/N 89016054130

ESCRIPTION

Locate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow the
instructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING
instructions for specific information.

LOWER DRIVE SHAFT ASSEMBLY - Includes the Debris Shield Assembly, Gear Housing assembly, Flexible Drive
Cable, Rapid Loader

Head and Safety Decals.

FLEXIBLE DRIVE CABLE - Cable end fits into upper drive shaft coupler. Lubricate drive cable every 25 hours with
ECHO

LUBE

grease.

PLASTIC DEBRIS SHIELD ASSEMBLY - Included in plastic bag (co-pack). MUST be installed on unit before use,
see Assembly Instructions. Shield assembly includes the Cut-Off Knife. Mounts on the Gear Housing Assembly
just above the cutting attachment. Helps protect the operator by deflecting debris produced during the trimming
operation. This shield must be replaced with the steel shield for blade use.

CUT-OFF KNIFE - Trims line to the correct length.

RAPID LOADER

HEAD - Contains replaceable nylon trimming lines.

EQUIPMENT

Before operation a complete check of the unit must be performed;

• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.

• Inspect shield for damage and ensure that cut-off knife is securely in place. Replace if shield is damaged or missing.

• Check that the cutting attachment is firmly attached and in safe operating condition.

• Check that front loop handle and shoulder strap/ or shoulder/waist harness are adjusted for safe, comfortable operation.

See Assembly Section for proper adjustment.