Eaton Electrical QSNAP - Manual (Page 22)

Intelligent Technologies (IT.) QSNAP
18 Pub. No. MN05001001E
February 2002
Wire the IT. QSNAP to the Starter
The QSNAP is connected to the IT. starter using a factory-provided jumper with an RJ-45 plug
on one end and a pigtail on the other. The pigtail is color coded to facilitate accurate
connection to the overload terminal block. Refer to the following figure and table when
wiring the terminal block.
Figure 9: Jumper and RJ-45 Plug
Table 18: Terminal Block Wiring
Use the following steps and illustrations to install the jumper.
1. Once the jumper is wired, insert the terminal block into the overload and the RJ-45
connector into J3 on the QSNAP as illustrated in Figure 10: Jumper Installation.
Figure 10: Jumper Installation
Starter RJ-45
GND 1
+24 2
P 3
F 4
R 5
1 6
2 7
3 8
1
1
RJ-45 Plug
1
IT. Starter Terminal Block
QSNAP
Jumper