Eaton Electrical QSNAP User Manual
Page 21
Intelligent Technologies (IT.) QSNAP
Pub. No. MN05001001E
17
February 2002
Use the following steps and the illustration in Figure 7 to mount the QSNAP.
1. Align both the QSNAP feet with the auxiliary contact mounting slots on the starter, as
illustrated in the figure.
Recommendation: Use the middle mounting auxiliary contact on the contact block when
mounting the QSNAP.
2. When the QSNAP is aligned, insert the feet into the detents and slide the QSNAP
towards the overload until a “click” is heard. This ensures that the QSNAP is mounted
securely to the starter.
Figure 7: QSNAP Alignment and Mounting
Note: To remove the QSNAP, press the “PUSH” tab protruding from the QSNAP while sliding
the QSNAP up and pulling away from the contactor block, as illustrated in Figure 8.
Figure 8: QSNAP Removal
1. Align and
Insert
2. Slide
2. Pull
Away
1. Slide