Electrolux TK SL5 E - Manual (Page 48)

Conductance of water at
installation site differs
from standard setting of
machine. Re-programme standard
setting for degree of dry-
ing (see ‘Programming
options’ chapter).
Loading door does not
close. Message on the
display: Please check if
the door is closed
properly and then press
START.
Fine strainer not in place
and/or mesh filter not
locked in place. Install fine strainer and/or
snap large mesh filter into
place.
When a button is pressed
- no reaction of the ma-
chine.
Drying protection. After
the start of the pro-
gramme, the option can
no longer be set.
Turn the programme
knob to OFF. Set the pro-
gramme again.
Drum light does not work.
Programme selector in
OFF position.
Turn programme selector
to LIGHT or to any pro-
gramme.
Defective light bulb.
Replace light bulb (see
next section).
Displayed programme
time changes erratically or
stays unchanged for a
long time.
Programme time is cor-
rected automatically de-
pending on type and vol-
ume of laundry and level
of dampness.
Automatic process; this is
not a machine fault.
Programme inactive,
massages: The tank is full.
Please empty it and then
press START or Please
empty the tank. are dis-
played.
Condensate tank is full.
Empty condensate tank,
then start programme
with START PAUSE but-
ton.
Drying cycle ends shortly
after programme starts.
Finished message is dis-
played. Not enough washing loa-
ded or washing loaded is
too dry for selected pro-
gramme. Select time programme
or higher drying level (e.g.
INTENSIVE DRY instead
of STORAGE DRY).
48 electrolux