Electrolux EWF 12040 W - Manual (Page 13)

use electrolux 13
Select the Delay start
Before you start the programme, if
you wish to delay the start, press the
Delay Start button repeatedly, to select
the desired delay. The relevant light
illuminates.
This button makes it possible to delay
the starting of the washing programme
by 2, 4, and 8 hours.
You must select this option after you
have set the programme and before you
press the Start/Pause button.
You can cancel the delay time at any
moment, before you press the
Start/Pause button.
If you have already pressed the
Start/Pause button, and you wish to
cancel the delay time, proceed as
follows:
• set the washing machine to PAUSE
by pressing the Start/Pause button;
• press the Delay Start button once, the
light relevant to the selected delay
goes off.
• press the Start/Pause button again to
start the programme.
Important!
• The selected delay can be changed
only after selecting the washing
programme again.
• The door will be locked throughout
the delay time. If you need to open
the door, you must first set the
washing machine to PAUSE by
pressing the Start/Pause button and
then wait about 2 minutes. After you
have closed the door, press the
Start/Pause button again.
2h 4h 8h
The Delay Start can not be selected
with Drain
programme.
Programme progress display
After having pressed the Start/Pause
button, the “wash”
pilot lights
comes on.
When the pilot light “wash” comes on
this means that the machine is
performing the washing cycle.
The “door” pilot light indicates if the
door can be opened:
• light on: the door cannot be opened.
The appliance is running.
• light off: the door can be opened.
The washing programme is finished.
• flashing light: the door is opening.
When the programme has finished, the
“End”
pilot light comes on.
Altering an option or a running
programme
It is possible to change any option
before the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
the Start/Pause button.
The options Daily, Light and Quick
c
ca an nn no ott be modified after the Start/Pause
has been pressed.
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to “O” and
then to the new programme position.
The washing water in the tub will not
132980282_EN.qxd 8/12/2008 10:23 AM Page 13