Epson Stylus CX4600 - Manual

Epson Stylus ® CX4600
Start Here
1 Open the paper support and pull up its extensions.
2 Open the output tray and pull out its extension.
3 Flip the feeder guard forward.
4 Slide the edge guide left.
5 Load paper against the right edge guide and slide the left edge
guide over.
6 Flip the feeder guard back.
4 Insert the cartridges in the holder for each color.
5 Press the cartridges down until they click.
6 Close the ink cartridge cover and press it down.
7 Close the scanner.
8 Press the ink button to charge ink. Charging takes about 2 minutes.
Caution: Don’t turn off the CX4600 while the On light is flashing or you’ll
waste ink.
Remove all the tape.
If any of these parts are missing, contact Epson ® as described on the back
of this sheet.
Unpack
Turn over
1
5
Load Paper
Caution: Don’t load paper before installing the ink cartridges.
1 Lift up the scanner.
2 Open the ink cartridge cover.
3 Shake the ink cartridges, then unpack them.
Install Ink Cartridges
4
4 ink cartridges
4049973-00 XXX
continue
1 Lift up the scanner.
2 Remove the tape from the ink cartridge holder.
3 Close the scanner.
Unlock the Printer
2
1 Connect the power cable.
2 Press the On button.
Turn On the CX4600
3
Paper support
Output tray