Aquapur Z31136 Lint Remover - Manual (Page 32)

32 GB/MT
Leaking or damaged batteries can
cause chemical burns if they come
into contact with the skin; in such
cases you must wear suitable protective gloves!
Remove battery if device is not used for long pe-
riods.
Do not short-circuit supply terminals under any
circumstances.
Inserting the batteries
To insert or replace the batteries, follow the
procedure described in figures B and C.
Preparing for use
Put the garment smoothly onto an even and
clean surface.
CAUTION! The lint remover may damage
textured or very soft fabrics such as Angora. Before
use, test the device and the different height
settings on an inconspicuous area in order to
prevent damage.
Do not oil or grease the cutting blade! Your
clothes could get dirty!
Switch the device on by sliding the I-/II -/ OFF
switch 2 to position “I” or “II”
Guide the glide piece 7 over the surface of the
garment using repeated, light, circular movements.
Note: You may speed up the process by switch-
ing to position “II” as described above.