Curtis SRCD268BT-PL - Manual (Page 11)

2. Plug into a 3.5mm audio cable (not included) into your external music player and
connect the other end (3.5mm jack) into the AUX IN jack on the top of the unit.
3. Make sure your external music player is turned on and start music playback on the
music player
4. Adjust VOLUME knob to control the sound level of music playback from the speakers
on the unit.
Power Output. . . . . . . . . . . . . . . . . . 1.2 watt RMS x 2 channels
AC Power . . . . . . . . . . . . AC120V~60Hz 14Watts
Battery Size . . . . . . . . . . . . . . . . UM-2 or C-Size batteries x 8 PCS
Radio Frequency. . . . . . . . . . . . . . . FM: 87.5 – 108MHz , AM: 520- 1710 kHz
Setting up (AUX IN) connection
AUX-IN jack will allow you to connect external music player or external sound source to the
main unit.
AUX IN Operation
Specifications
10
The unit is designed to receive FM Stereo / FM and AM radio bands.
1. Switch and toggle the FUNCTION button on the top of the unit to switch to AM
or FM mode.
2. Adjust the TUNING knob on the top of unit to tune the frequency of desired radio
station.
3. To turn off the unit power, press the button to switch off the unit.
Remark:
The unit has built-in AM ferrite bar antenna, which can provide adequate reception in
most areas. If the AM reception is weak, try to adjust the location of the unit or
relocate the unit to improve the reception. If the FM reception is weak, try to adjust the
length and the angle of the FM antenna to improve the signal reception.
Radio Operation
1. Adjust the FUNCTION Switch to CD mode.