Curtis SCR4986 - Manual (Page 8)

POWER SOURCE
This unit operates from AC120V/60Hz line power supply.
AC OPERATION
Connect AC Power Cord to a wall outlet with AC120V/60Hz power supply.
RADIO OPERATION
1. Power the unit ON if STANDBY mode by pressing the STANDBY ON/OFF button(#3)
The default mode is RADIO,if the unit was already ON, and in CD mode,you will need to press
the FUNCTION button(#8) to switch to the RADIO mode.
2. Set the band to either AM or FM by pressing the PLAY/PAUSE/BAND button(#1) while in
RADIO mode.
3. To tune a station,press either REV/TUN- or FWD/TUN+ buttons(10,11) to skip up or down
the frequency range.Press and hold either button to fast search up or down the frequency
range.When a station is found the search will stop&the station will begin playback.
4. Use the AL 1/VOL- or AL 2/VOL+ buttons(13,14) to adjust the volume level.
NOTE: To improve FM reception you can relocate the antenna cable.To improve AM reception
the unit will need relocating to an area with better reception.
Storing@recalling presets
You can store up to 10 preset radio stations per radio band.
1. While listening to a tuned radio station,press and hold the STOP/PRESET button(#2) to
display the preset location option.Use the REV/TUN-& FWD/TUN+(10,11) buttons to cycle
through the available preset location 1-10.
2. When the location is selected press the STOP/PRESET button once more to store the current
station in the selected preset location.
3. To recall a preset station press the STOP/PRESET button(#2),use the
REV/TUN-&FWD/TUN+(10,11) buttons to cycle through the available preset locations
1-10.When the correct location is selected leave all buttons untouched for 2 seconds to begin
playback.
BASIC CD OPERATION
1. Power the unit ON if STANDBY mode by pressin the STANDBY ON/OFF(#3).The default
mode is RADIO,so press the FUNCTION button(#8) to switch to the CD mode.
2. Open the CD door by pressing the OPEN/CLOSE door release button(#9).Inset a CD with the
label facing upwards and close the door.
3. The unit will read the disc and display the total number of tracks found on the disc on the
display
4. To begin playback press the PLAY/PAUSE/BAND button(#1).The first brack on the disc will
play.
5. To pause playback press the PLAY/PAUSE/BAND button(#1) once more.Pressing again