Electrolux EWF 14170 W - Manual (Page 14)

14 electrolux use
Opening the door after the
programme has started
First set the machine to pause by
pressing the “Start/Pause” button.
If the “door”
light flashes and after
2 minutes goes off, the door can be
opened.
If the “door”
light does not switch
off, this means that the machine is
already heating, that the water level is
above the bottom edge of the door or
that the drum is turning.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to “O”. After about 2 minutes the door
can be opened (pay attention to the
water level and temperature!).
At the end of the programme
The machine stops automatically. The
phase light “end”
illuminates,
“wash” , “door” and the
“Start/Pause” light go off and the door
could be opened.
If the Rinse Hold option has been
selected, the phase lights “end” and
“door” illuminate, the
“Start/Pause” light goes off and the
door remains locked to indicate that the
water must be emptied out before
opening the door.
To empty out the water please read
the steps on the Rinse Hold option
paragraph.
Turn the programme selector dial to
“O” to switch the machine off. Remove
the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
132967750_EN.qxd 29/10/2007 9.57 Pagina 14