Curtis FRF452B - Manual (Page 5)

damage the compressor and the sealed system.
 If the freezer is tilted let it stand in an upright position for at least 24 hours prior
to plugging. This is to allow the refrigerant to settle.
English
Proper Air circulation
 To assure your freezer works at the maximum efficiency it was designed for, you
should install it in a location where there is proper air circulation, plumbing and
electrical connections.
 The following are recommended clearances around the refrigerator:
Sides……………4”(102mm)
Top………………4”(102mm)
Back……………..4”(102mm)
Electrical requirement
 Make sure there is a suitable power outlet(115V,60HZ outlet) with proper
grounding to power the freezer.
 Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, we strongly
recommend that a certified technician performs the service. And note the marked
rating of the extension cord must be equal to or greater than the electrical rating
of the appliance.
Install limitations
 Do not install your freezer in any location not properly insulated or heated e.g.
garage etc. Your freezer was not designed to operate in temperature settings
below 55℉ahrenheit.
 Select a suitable location for the freezer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
Any floor unevenness should be corrected.
FREEZER FEATURES AND USE
Operation your freezer
 Once the freezer is in its proper place, plug it in an electrical outlet having
115V/60HZ. Turn on power switch. Power light will come on, the green ”run”
light will be lit indicating that the freezer compressor is in operation.
 Set the temperature, on the temperature control knob,”1”being the warmest and