Technical specifications – Euro-Pro WATER FILTRATION VACUUM CLEANER CW230H User Manual

Page 4

GETTING TO KNOW YOUR WATER FILTRATION VACUUM

OPERATING INSTRUCTIONS

Cleaning / Replacing the Pre- Motor

Filter

The pre-motor filter is a washable filter but

should be replaced every three (3) to six

(6) months depending on usage.

1. Unplug the unit from electrical wall

outlet.

2. Lift the locking tabs on either side of

the water tank.

3. Remove the cover. The pre-motor filter

is located on the underside of the

cover. (Fig. 13)

4. Remove the pre-motor filter.

5. Rinse the pre-motor filter in lukewarm

water and let the filter air dry

completely for 24 hours. Do not use a

washing machine to rinse the filter. Do

not use a hair dryer to dry it. Air dry

only for 24 hours. Never operate the

vacuum without the pre-motor filter in

place.

6. When the pre-motor filter is completely

dry, replace it into the cover of the unit

and replace the cover onto the unit.

7. A severely soiled or clogged filter

should be thoroughly washed with

fresh tepid water. A mild detergent can

be used if required.

9. The water tube should also be

thoroughly washed. A mild

detergent may be used if required.

Cleaning the Flexible Hose

When using the flexible hose for picking

up liquids or other soft foods such as baby

foods or ketchup, always rinse the flexible

hose with warm water after each use

before the dirt hardens on the inside of the

flexible hose.

1. Empty the water tank of all

accumulated water and dirt.

2. Reattach the flexible hose to the

canister.

3. In a pail, pour 3 cups of warm water.

4. Turn the unit “On” and insert the

flexible hose into the pail to suck up

the water. This will rinse out the inside

of the flexible hose.

5. Once you have finished, empty the

water tank again and store your unit

away.

Pre-Motor

Filter

Fig. 13

Cover

11. Manual Suction Control
12. Flexible Hose Handle
13. Flexible Hose
14. Small Squeegee
15. Air Driven Turbo Brush
16. Convertible Brush
17. Large Squeegee
18. Extension Tubes (x2)
19. Crevice Tool
20. Triangular Water Brush
21. Floor Brush

Water Tank

Power Cord

Extension Tube Holder

Locking Tab (x2)

Carry Handle

On/Off Power Switch

Air Intake Opening

Cyclonic Dust Cup

Cyclonic Air Intake

10. Cyclonic Dust Cup Lock

NOTE:

DO NOT IMERSE THE

ELECTRICAL PART OF THE

VACUUM INTO WATER OR ANY

OTHER LIQUID.

Technical Specifications

Voltage:

120V., 60Hz.

Power:

5 Amps, 600 Watts

* Illustrations may differ from actual product.