Curtis IP1134UK - Manual (Page 2)

ENG-4
Safety Precautions
IMPORTANT INFORMATION
This product is designed for use in moderate climate. Do not use or install this unit where it would be exposed to direct
sunlight or in extremely hot temperatures, or near a radiator, stove or appliance that produces heat.
Do not take this unit into the bathroom, or near a swimming pool. Do not use it where it would be exposed to water,
moisture, dripping or splashing.
No objects filled with liquids, such as vases, placed on the product.
No naked flame sources, such as lighted candies on the product.
If water gets inside the unit, Unplug the power cord from the supply socket and consult your dealer.
Do not handle the power cord with wet hands. To avoid electric shock, NEVER touch any internal parts.
Repairs/servicing should be left to qualified service personnel.
When connecting or disconnecting from the mains supply, hold the plug but not the cord. Pulling the cord may
damage it and is dangerous.
Do not drop the unit, spill liquid into it or allow objects to fall in it.
When plugged in, a very small current will flow. To save electricity and for safe, it is recommended that the product is
completely disconnected with the AC mains socket after the unit not used for a long time.
Consult your nearest dealer when damage, disconnection or contact failure is found with the cord.
Do not bend the cord sharply, pull or twist it.
Do not modify the power cord in any manner.
Do not insert any metallic object in the unit.
Unplug the power cord when there is the possibility of lighting.
Mains plug is used as the disconnecting device. It shall remain readily operable and should not be obstructed
during intended used.
To be completely disconnected the apparatus from supply mains, the mains plug of the apparatus shall be
disconnected from the mains socket outlet completely.
In case of malfunction due to electrostatic discharge, just reset the product reconnect of power source may be
required to resume normal operation.
POSITIONING THE UNIT
A minimum distance of 6 INCHES must be kept to provide sufficient ventilation.
Do not place the product in closed bookcases or racks without proper ventilation.
Allow adequate ventilation for the unit ventilation. It should not be impeded by covering the ventilation openings with
items such as newspapers, table cloths, curtains etc .
Do not stand it on a thick pile carpet, install it in a thick pile carpet, or install it in a place with inadequate air flow. Place
the unit on a flat even surface.
Do not use the unit in excessively hot, cold, dusty, damp or humid place.
Condensation may form inside the CD player if the unit is left anywhere warm and damp, or if you move the unit from
somewhere cold to a warm room. In this case, let the unit stand for 1-2 hours or gradually increase the room
temperature that the unit will be dry before use.
Do not place it where it could be subject to vibration.
Do not place it where it could be magnetised by a magnet or speaker. Since there are magnets, do not place tapes as
recorded data could be erased.
When this unit is used near a TV, the TV picture could be distorted. If this happens, move the unit away form the TV. If
the situation could not be solved, avoid using the unit when the TV is turned on.
Keep the CD door closed so the lens is not contaminated by dust. Do not touch the lens.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Warning: excessive sound pressure from earphones and headphones can cause hearing loss.
Attention should be drawn to the environmental aspects of battery disposal.
SAFETY MECHANISM
This unit incorporates a safety interlock mechanism that switches the laser beam on and off, when the disc holder is
open, the laser baser beam stops automatically.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
RIS K OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO MINIMISE THE RISK OF ELECTRIC SHOCK,
NEVER REMOVE THE COVER. THIS PRODUCT CONTAINS
NO USER-SERVICEABLE PARTS. ONLY QUALIFIED REPAIR
TECHNICIANS SHOULD WORK ON THIS EQUIPMENTS.
CAUTION
WARNINGS
To reduce the risk of fire or electric shock, do not expose this
product to rain or moisture.
The lightning symbol inside an equilateral
triangle warns the user of the presence inside
the product of uninsulated hazardous electric
voltages powerful enough to represent an
electrocution risk.
The exclamation mark symbol inside an
equilateral triangle warns the user that
i m p o r t a n t o p e r a t i n g a n d s e r v i c i n g
(troubleshooting) instructions are contained in
the documentation accompanying the product.
EXPLANATION OF GRAPHIC SYMOBOLS.
HAZARD WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR MOISTURE.
PRECAUTIONS FOR USE
To ensure safe use of this product, please follow the advice below:
Positioning
Power supply
Safety instructions
Condensation
In the event of a problem, unplug the power cord and contact a qualified repair technician.
Ventilation precautions
Warning concerning liquids
Do not allow liquids to splash or spill onto the product, and never stand a liquid-filled container
(vase, jar, etc.)on the top of it.
Warning concerning excessive sound levels
Do not use the product in extremely hot, cold, dusty or damp condition.
Place the product on a smooth, flat surface.
Do not obstruct the flow of air through the product. Place it on a well-ventilated position; do not
cover with fabric or stand on a rug or carpet.
Before using this product, check that its rated voltage matches your mains power supply
voltage.
Never pull on the power cord when plugging in or un-plugging the product: always use the plug
pulling the cord could damage it and create a risk of electric shock.
Unplug the product from the mains socket if you do not intend to use it for an extended period.
The On/Off button does not isolate the product from the power supply. To disconnect the
product from the mains power supply, you must unplug the power adaptor.
This product should only be used in a horizontal position.
Mains plug is used as the disconnecting device. It shall remain readily operable and should not
be obstructed during intended used.
Water droplets or condensation may from inside it is moved into a very warm, humid
atmosphere.
Condensation can cause the product to malfunction.
Leave the set in a warm room for 1 to 2 hours to allow the condensation to evaporate.
Never obstruct the product’s ventilation holes.
Owing to this product’s extremely low noise output and extended dynamic range, the user may
be tempted to turn up the volume louder than necessary. The sound output may be excessively
high, to the point of damaging the product’s headphones or loudspeaker. Always keep the
volume within reasonable limits.
ENG-3
Warnings and Precautions