beautypg.com

Operating instructions, Control panel – Electrolux CH 910 User Manual

Page 6

background image

6

OPERATING INSTRUCTIONS

The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
The appliance can be installed to recirculate or extract contaminated air.

Control Panel

The hood can be switched on pushing directly onto the requested speed without fi rstly having
to select 0/1 button.

L T1 T2 T3 T4 T5 F

Touch

Basic functions

Indicator lights

Dual Function

L

When briefl y pressed it switches the lighting system on/off.

Touch control unlit

Lights off

When pressed for 2 seconds it starts the lighting system
in “courtesy light" mode.The lamps are fed at a reduced
power of approximately 5W. Such function can be stopp-
ed by pressing the touch control for 2 seconds or just by
pressing it shortly in order to return to the normal lighting
mode. In courtesy light mode the touch control is not lit.

Touch control lit

Lights on

Touch control unlit

Courtesy light on

T1

When pressed the motor is stopped, regardless of the
speed it is set to.

Touch control lit

Motor on

Touch control unlit

Motor off

T2

When pressed the motor is set to the fi rst speed

Touch control lit

T3

By a brief pressing the motor is set to the second speed.

Touch control lit

Second speed on

By pressing the touch control for approximately 2 seconds the
Delay function is enabled, i.e delayed shutdown of the appli-
ance ensuring a complete elimination of the residual odours.
This function can be activated at OFF- position and at 1°, 2°
and 3°speeds. It can be stopped in advance by pressing any
of the touch controls (T) with the exception of T3. The Delay
function works according to the following scheme:

1°speed / OFF = 20 minuets
2°speed =15 minutes
3°speed = 5 minutes

Flashing touch control Delay function on

T4

When pressed the motor is set to the third speed

Touch control lit

T5

When pressed the motor is set to the intensive speed
timed to 5 minutes. At the end of 5 minutes of intensive
speed the hood starts again at the speed it was set to
previously. In case the hood is set to the intensive speed
directly from OFF-state it will then start from the fi rst
speed after 5 minutes of intensive speed.

Touch control lit

F

When pressed for 4 seconds it resets the fi lter alarm s-
ignal indicated by fl ashing of the touch control T1.This
procedure can be carried out only when the motor is
stopped.

Touch control lit

Metal grease fi lters saturation
alarm.Metal grease fi lters need
to be washed.The alarm starts
up after 100 working hours.

Flashing touch control

Charcoal odour fi lter saturaion
alarm.Charcoal fi lter has to
be replaced and metal grease
fi lters washed.The alarm
starts up after 200 working
hours.(Activation; check the
paragraph "Odour fi lter"

)