Electrolux 68001KF-N - Manual (Page 22)

22
What to do if
…
Problem Possible cause Remedy
The cooking zones will not
switch on or are not func-
tioning More than 10 seconds have
passed since the appliance
was switched on Switch the appliance on
again.
The lock is switched on
l
Switch off the lock (See
the section “Locking/un-
locking the control panel”)
The child safety device is
switched on
l
Deactivate the child safety
device (See the section
“Child safety device”)
Several sensor fields were
touched at the same time Only touch one sensor field
The sensor fields are partly
covered by a damp cloth or
with liquid Remove the cloth or the
liquid.
Switch the appliance on
again.
Safety cut-out has been
triggered Switch the appliance on
again
STOP+GO is activated Switching off STOP+GO
The residual heat indicator
is not displaying anything The cooking zone was only
on for a short time and is
therefore not hot If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
The automatic warm up
function is not switching
itself on There is still residual heat
on the cooking zone
h
Let the cooking zone cool
down
The highest heat setting is
set
Ç
The highest heat setting
has the same power as the
automatic warm up func-
tion
The heat setting was set
using the sensor field 1. Switching off the cook-
ing zone
2. Set the cooking zone us-
ing the sensor field
Repeated acoustic signal
(6x), appliance switches off One or more sensor fields
have been covered for
longer than 10 seconds Uncover sensor field
Display is switching be-
tween two heat settings Power management is re-
ducing the power of this
cooking zone See the section “Switching
the power function on and
off”