Electrolux 65050 VI - Manual (Page 44)

Installation and Connection Instructions
44
Leak prevention system
To avoid damage caused by water leakage, the dishwasher is equipped
with a leak prevention system.
In the event of a fault, the safety valve in the appliance immediately
interrupts the inflow of water and the drain pump is activated. In this
way water can neither escape nor overflow. Any remaining water in the
appliance is automatically pumped out.
1 The leak prevention system also works when the appliance is switched
off – the appliance must however not be disconnected from the mains.
In the event of a fault when the appliance is switched on, a buzzing
tone can also be heard.
Electrical Connection
Any electrical work required to install this appliance should be car-
ried out by a qualified electrician or competent person.
1 WARNING - This appliance must be earthed.
The manufacturer declines any responsibility should these safety
measures not be observed.
Before switching on make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug.
Important: The plug must still be accessible after the appliance has
been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav-
ing to change the fuse in the plug supplied, a 13amp ASTA approved
(BS 1363A) fuse must be used.
Should the plug need to be
replaced for any reason, proceed as
described below.
The wires on the mains lead are
coloured in accordance with the
following code.
Green and Yellow : Earth
Blue
: Neutral
Brown : Live
Blue
Green
& Yellow
Brown
Cord Clamp