Curtis RCD4400 - Manual (Page 6)

– Problem
• Solution
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly /
No reaction to operation of any of
the controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
no disc indication
– No CD inserted
• Insert a CD, CD-R or CD-RW
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R is blank or the disc is not finalized
• Use a finalized CD-R
CD playback does not work
– CD badly scratched/ dirty
• Replace/ clean CD (see maintenance)
– Laser lens steamed up
• Wait until lens has adjusted to room temperature
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– Program is active
• Quit Program mode(s)
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the
warranty.
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3 materials: cardboard,
paper pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe
the local regulations regarding the disposal of packaging, dead batteries and old equipment..
TROUBLESHOOTING
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
I ) for recording
10
SPECIFICATIONS :
POWER SUPPLY
RADIO FREQUENCY COVERAGE
GENERAL
Headphone
Speakers
CD PLAYER
Pick up
Encoding
D/A
CASSETTE PLAYER
Tape
Recording System
Erasing System
: AC 230 V, 50 Hz
DC 12V (UM-1 x 8)
: AM 530 - 1710 kHz.
: FM 88 - 108 MHz.
: 3.5mm Stereo jack plug 8-32 ohm
: 8 ohm
: 3-Beam. Semiconductor Laser
: 8 x Over Sampling
: 1 - Bit Dual D/A Converter
: Standard normal bias
: DC bias
: Magnetic erase
SPECIFICATION
11