Curtis RCD877 - Manual (Page 9)

CASSETTE OPERATION
" Playback
Playback a pre-recorded tape
1. Press the TAPE button once and the “TAPE” indicator
light up on the display.
2. Press the cassette door open, then the cassette door
eject button and insert a recorded cassette.
3. Press the PLAY button.
4. Adjust the VOLUME control for your desired level.
5. Press the STOP button to stop playback at any time.
When the end of the tape is reached, the tape will
automatically stop.
" Winding The Tape
1. Press F.F. to fast-foward the tape.
2. Press REW to fast-rewind the tape.
3. Press STOP to stop fast-forward or fast-rewind,
before the end of the tape.
" ALC (Automatic Level Control)
Recording
This unit has an ALC circuit and no further adjustment is
necessary.
A) Recording from the built-in radio
1. Tune in a desired radio programme as described in
“RADIO OPERATION” section.
2. Press the OPEN CASSETTE DOOR button, then the cas-
sette door eject.
3. Insert a cassette & close the cassette door.
4. Press the REC button.
5. Since you can monitor through the speakers with-
out affecting the of recording level, you can ad-
just the VOLUME and other controls.
6. Press the STOP button to stop recording at any time.
B) Recording from the CD player
Proceed the CD play operation as described in “PLAY-
ING A COMPACT DISC”.
" Pause
Press the PAUSE button of momentarily stop tape travel
during recording. Re-press the button for pause release
and recording restart.
RADIO OPERATION
Press the TUNER & BAND button to selet the Radio operation.
" " " " " Listen to radio
1. Press TUNER button to select waveband range
will appear on the display.
2. Select the desired waveband range with the BAND
button.
" " " " " Automatic tuning
1. Press TUNING UP/DOWN for a second or more, then
release the button. The tuner will automatically for first
station of sufficient signal strength.
2. Press above procedure if you wish to select another
station.
" " " " " Manual tuning
1. To tune to weak stations, use manual tuning by
pressing TUNING UP or DOWN button continuously
until you read the correct frequency or the reception is
at its best.
2. When you want to select FM stereo station, press the
FM MODE button on STEREO first . When you receive
a FM stereo station the “STEREO” indicator appear
on the display, you can receiving FM stereo tramission.
3. When you press the FM MODE button to MONO,stop
the stereo recieving.
STORING STATION
When beats are produced while listening to or recording
a AM broadcast, active the beat cut switch so that the
beats are eliminated or minimized
BEAT CUT
UK-8
1. 20 station for all bands that can be stored in memory,
you can tune in the stored station directly by entering
the memory number.
2. Select your desired band.
3. Tune in the desired station
4. Press MEMORY/C-ADJ. button ‘MEMORY” indicator
will flash on the display.
5. Press M.-UP button to select the channel.
6. Press MEMORY/C-ADJ. button to store the station.
7. Repeat above steps for each station stored.
Note :
1. You can not erase a previously stored station, but
storing a new station will exchange the previous one.
2. If no power supplied, then stored station are erased.
Please store station again.