Curtis DVD1056 - Manual (Page 19)

The Setup Menu System
19
receiver or decoder.
! SPDIF / PCM: Choose this setting if your DVD player is connected to a 2-channel
digital stereo amplifier; When playing a disc recorded with Dolby Digital and
MPEG audio formats, audio signals will be modulated into a 2-channel PCM signal,
and it will be output from the Coaxial Output jack or Optical Output jack.
d) VIDEO SETUP
$ BRIGHTNESS
Use the Up and Down arrow button to move the scroll and adjust the brightness.
$ CONTRAST
Use the Up and Down arrow button to move the scroll and adjust the contrast.
$ HUE
Use the Up and Down arrow button to move the scroll and adjust the hue.
$ SATURATION
Use the Up and Down arrow button to move the scroll and adjust the saturation.
e) SPEAKER SETUP
$ DOWNMIX
Use the Up and Down arrow button to move the scroll and adjust the saturation.
! LT / RT: Choose this setting, it will be sound like in a movie theatre if the original
movie the disc was recorded from was encoded in the Pro Logic Dolby Digital
format.
! STEREO: Choose this setting, when 5.1-channel sound playing, two channels of
signals will be output from the left and right soundtrack; when 2-channel sound
playing, stereo signal will be output.
! VSS: Choose this setting, when a disc recorded with 5.1-channel sound format
playing, the fictitious surround soundtracks effect will be heard from the main
soundtrack.
f) DIGITAL SETUP
The video setup options are illustrated below:
$ OP MODE
! LINE OUT: Choose this setting to line out the input signal. It will be more suitable
for playing in the night time, for the output volume is low.
! RF REMOD: It will be more suitable to choose this setting for playing in the day
time, for the output volume is high.
$ DYNAMIC RANGE: When “LINE OUT” is selected, choose this setting to adjust the
line out ratio and get different effect. If adjusting to FULL, the audio signal peak value
will be the minimum; while adjusting to OFF, maximum.
NOTE:
This option will be validated when the DOWNMIX OFF.