Electrolux 45250Vi User Manual
Page 31
31
Position and connection instructions
Mounting the outer door
1. Unscrew the screws on the
mount plate. Lift the plate off
together with the door.
2. Lay the machine down on its
back. Check that none of the
hoses are trapped. Insert the
guide rods into the plastic door
guides.
3. Slot the tabs on the mount plate
into the holes on the front plinth
of the machine and screw the
mount plate into place using
the 2 screws provided.
Fitting protective and cap
strips
In order to fill the gap between the cup-
board and the dishwasher and to protect
the cupboard above from any steam that
comes out of the washer, a self-adhesive
protective strip is attached along the
upper edge of the cupboard and two
gap strips are attached along the edge
of the cupboard.
1. Clean all surfaces where the
strips are to be attached to
ensure better adhesion.
2. Attach the protective strip along
the upper edge of the cupboard.
If it is too long, it can easily be
cut to the right length.
3. Attach the two gap strips along
each side of the cupboard, level
with the front edge of the sides.
Tab
english AEG F45250Vi UK 2-12-17 16.19 Sidan 31