Electrolux 45250Vi - Manual (Page 12)

Filling the rinse aid
Use of rinse aid will result in cleaner and faster drying of the load, since it
helps water and soil to run off. Too much rinse aid may result in streakiness,
too little may cause white spots.
Caution!
Only use rinse aid specifically designed for domestic dishwashers. Never fill
the rinse aid dispenser with any other substance (e.g. vinegar concentrate
or dishwasher detergent) as this would damage the appliance.
The rinse aid dispenser is on the inside of the dishwasher door.
1. Open the lid to the dispenser by
pressing the lid catch towards the
compartment and lift the lid.
2. Fill up with rinse aid; do not overfill.
The dispenser will hold approx. 150 ml.
3. Wipe off any spillage carefully to
prevent excessive foaming during
the next wash programme.
4. Close the lid and press until it locks
again.
Fill with rinse aid:
When the indicator light on the control panel is lit.
Switching the rinse aid dispenser off
If dishwasher detergent with rinse aid is used, you can switch off
the rinse aid dispenser and the lamp that indicates that the rinse aid
dispenser is empty.
The dishwasher must be switched off.
1. Press in the On/Off button.
2. Press the combination buttons simultaneously and hold them pres-
sed in. When the first three programme indicator lamps starts to
flash, you can let go of the buttons.
3. Press the rinse aid button once. The lamp for the rinse aid button
starts to flash and the lamp for the end of programme is lit.
Press the button once more and the lamp for the ended programme
cycle goes out. Now the function for the rinse aid dispenser is off
and the control lamp is out.
4. Press out the On/Off button to complete the setting.
To reset the function, follow steps 1 and 2 above and then press
the rinse aid button twice, until the lamp for the ended programme
cycle is lit again.
12
Instruction book
english AEG F45250Vi UK 2-12-17 16.19 Sidan 12