Emerson Radio CKS3095S - Manual (Page 17)

1 6
Listening To The Radio
Digital Radio Frequency Display
This clock radio features a digital radio frequency display instead of a dial scale to
make tuning easier, especially in a dark room. The jumbo LED time display
automatically changes to a radio frequency display as soon as you begin turning
the TUN. (Tuning) control. And the display automatically changes back to the correct
time within 10 seconds after you release the TUN. (Tuning) control.
1.) Set the Band FM/AM selector switch to the desired band, AM or FM.
2.) Set the VOL. (Volume) control to a low setting.
3.) Press the RADIO ON/OFF button to turn
the radio ‘On’. The display changes from time
to an AM or FM radio frequency display.
4.) Turn the TUN. (Tuning) control counter-clockwise to select higher numbered
frequencies or clockwise to select lower numbered frequencies.
Important: It is not necessary to tune to the exact frequency of your
desired station. Just rotate the TUN. (Tuning) control until you find
the strongest signal and the best reception, even if the frequency
number on the display is higher or lower than the actual station
frequency.
Within 10 seconds after you release the TUN. (Tuning) control the display
automatically changes back to the correct time.
5.) Adjust the VOL. (Volume) control to the desired setting.
6.) When you are finished listening, press the RADIO ON/OFF button to turn
the radio ‘Off’.
CKS3095_041707.p65 17/4/2007, 16:06 16