Eureka 1040 Series - Manual (Page 7)

HO
W T
O
USE
Electrical Cord - For shipping purposes, the electrical
cord is stored inside the tool box . Open lid latches, lift tool
tray up, to remove electrical cord.
LiftTool Tray
Plug round end of electrical cord into the tool box, as shown
above. Plug the other end of electrical cord into electric
socket.
The electrical plug has been designed so an electric tool or
appliance can be plugged directly into it.
Cover unused receptacle when not in use with outlet cover
(attached to cord as shown).
ON/OFF Switch. International symbol I means On,
International symbol O means Off.
ON/OFF
Switch
Suction Inlet. Insert larger end of hose into
suction inlet to use as a vacuum.
Suction
Inlet
Blower Port. Insert larger end of hose into the
blower port to use as a blower.
Blower Port
Outlet
Cover
NOTE: Always wear safety goggles (not provided). Never
point blower toward people, animals or objects
that may be injured/damaged by flying debris.
These units must NOT be used to power a paint
sprayer or to supply air to any other sprayer.
1.To use accessories remove hose from top of the lid by
lifting up.
2.Place desired accessory onto end of hose or crevice wand.
Dusting/Upholstery Brush is for furniture, blinds,
books, lamp shades, shelves, curtains, draperies, cushions
and fabrics.
Crevice Wand cleans corners, stairs, baseboards, and
between cushions.
Dusting/
Upholstery
Brush Crevice
Wand
Hose
or
Wand
Accessories - The accessories are stored on the inside
of the tool box lid. There are diagrams on the inside of the lid
to help with placing them back in the correct location.
Extension Cords
NOTE: If an extension cord is used, make sure the plug
connection does not come into contact with any
liquid. Use a grounded extension cord with 3-prong
plug and 3-pole receptacle; 16 gauge, SJTW-A type.
Loop the cords to prevent unplugging.
7