beautypg.com

Impor tant informa tion – Eureka 1040 Series User Manual

Page 5

background image

GENERAL INFORMATION

The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to
prevent hose clogs.
If an extension cord is used it must be 3 wire, grounded type and marked SJTW (suitable for outdoor use) 16
AWG minimum.

Service Information

The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone
our toll free number for the nearest Eureka Authorized Warranty Station. You should know the model, type and
serial numbers when you call:

USA: 1-800-282-2886

Mexico: 5670-6169

Canada: 1-800-282-2886

If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois
61701, USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The
Eureka Limited Warranty for complete service information.

DO NOT OIL the motor at any time. The bearings are permanently lubricated and sealed.

Rating Plate

The model, type, and serial numbers are indicated on the rating plate
located on the top of the motor compartment inside the toolbox. For
prompt and complete service information, always refer to these numbers
when inquiring about service.

Model & Type__________________________

Serial No. _____________________________

MODEL TYPE SERIAL NO.

VOLTS AMPS. HERTZ

SERVICE INFORMATION: 1-800-282-2886

THE EUREKA COMPANY

BLOOMINGTON, ILLINOIS 61701

IMPOR

TANT INFORMA

TION

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly
shuts off, push the on/off switch off (0) and unplug the cleaner. Check the cleaner for a possible source of overheating such as
a full dust bag, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before
attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and push the on/off switch on (l). If the
cleaner still does not run, then take it to a Eureka Authorized Service Center for repair.

5