Parkside PNTS 1300 C3 - Manual (Page 12)

12
GB
Trouble shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage is not present
Check plug socket, cable, line,
plug and fuse, where appropri-
ate, repair through electrical
specialist
Defective on/off switch
( 3)
Repair through customer service
Worn carbon brushes
Defective motor
Low or lack of suction
Hose system ( 13/14) or
jets ( 18/19) blocked
Remove obstructions and block-
ages
Suction pipe ( 12) assem-
bled incorrectly
Assemble suction pipe correctly
Container ( 6) open Close container
Container ( 6) full Empty container
Filter ( 15/16/17) full or
clogged
Empty, clean or replace filter
Float in filter basket ( 21)
incorrectly positioned (e.g.
due to jerky movements)
Switch off the equipment so the
ball drops then switch on again
Float in the filter basket
( 21) faulty
Repair by Customer Care
Float does not switch
the appliance off
Float in the filter basket
( 21) does not move
Release float
Float in the filter basket
( 21) faulty
Repair by Customer Care
Dust or dirt is blow
out of the device
Filter ( 15/16/17) is not
or not correctly assembled
Use missing filters or check the
correct position of the filter