Parkside PLS 48 B1 - Manual (Page 62)

62 GB
Using the product
Q
Solder sponge
CAUTION! The hot soldering tip 7 must never be placed in
contact with a dry solder sponge 5 , otherwise the solder sponge
may be damaged.
The solder sponge 5 is used to clean soldering tips.
Moisten the solder sponge 5 before you use it.
Q
Soldering
If inhaled, vapours may cause headaches and fatigue as
well as other symptoms.
— The soldering pencil has a rated output of 48 watts and is therefore
ideal for electronics soldering (see Figs. A, B).
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
Clean the soldering tip 7 on the moist solder sponge 5 .
After cleaning the tip 7 it must be “tinned” (coated with solder).
This is done by melting solder on to the hot soldering tip 7 .
Guide the soldering tip 7 to the intended joint site and heat the joint.
Place the solder (with flux) between the joint site and the tip 7
to melt it.
Continue to feed further solder until the whole joint has a covering
of solder.
Then quickly remove the soldering tip in order to avoid overheating
the molten solder.
Allow the solder to harden while not subjecting it to vibration or
movement.
Note: The flux is either already contained in the solder or applied
separately.
… / Maintenance and cleaning / Service centre