Parkside PNKP 105 A1 - Manual (Page 9)

9 GB
affected area under cold running water for several minutes. Do not
try to remove the glue from your skin.
Always run the power cable away from the appliance to the rear.
original accessories / tools
Use only the accessories and attachments detailed in the operating
instructions, or those which are compatible with the device.
Start-up
prepare the area to be glued:
Do not use any flammable solvents to clean the area.
The room temperature and the temperature of the material to be
glued may not be colder than +5 °C and no warmer than + 50 °C.
The area must be clean, dry and grease free.
Smooth out the surface before gluing.
Warm up cooled material such as e.g. steel for a better join.
1. Fold the stand leg 4 out. Set the device aside.
2. Put a glue cartridge in the feed canal 1 .
3. Let the device warm up for 5 minutes. The device is now ready to use.
Gluing:
Press the feed trigger 3 to start and control the flow of glue.
1. Apply the glue in dots. Apply the glue in a zigzag line on flexible
material e.g. textiles.
Safety instructions / Start-up Safety instructions