Parkside PHLG 2000 C2 - Manual (Page 24)

24 GB/MT
General safety advice Introduction / General safety advice
Heat gun PHLG 2000 C2
For removing, reshaping, preheating,
defrosting etc.
Q Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.
Q Proper use
The heat gun is intended for the removal of paint,
for warming (e.g. heat-shrinkable sleeves) and for
reshaping and welding of plastics. The hot air blower
can additionally be used to dissolve solvents, to thaw
water pipes and for lighting grills. Any other use or
modification to the device shall be considered as
improper use and could give rise to considerable
dangers. The manufacturer will not accept liability
for loss or damage arising from improper use. The
device is not intended for commercial use.
Q
Features and equipment
1 Air inlet
2 ON / OFF switch & temperature and
air volume regulator
3 Nozzle
4 Protector nozzle
5 Flat nozzle
6 Reducer nozzle
7 Barbecue lighting nozzle
Q Included items
1 Heat gun PHLG 2000 C2
1 Protector nozzle
1 Flat nozzle
1 Reducer nozzle
1 Barbecue lighting nozzle
1 Operating instructions
Q Technical information
Nominal voltage: 230 V∼ 50 Hz
Power consumption: max. 2000 W
Air volumes:
Setting I: ca. 300 l / min.
Setting II: ca. 500 l / min.
Temperatures
(Jet outlet nozzle): Setting I: ca. 350 °C
Setting II: ca. 550 °C
Protection class: II /
The sound pressure level (A) of the device is typically
less than 70 dB (A).
Q General safety advice
Read all the
safety advice and instructions!
Failure to observe the safety advice
and instructions may result in electric shock, fire
and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
Keep the device away from rain or
moisture. Water entering an electrical device
increases the risk of electric shock.
Do not use the mains lead for any
purpose for which it was not intended,
e.g. to carry the device, to hang up the
device or to pull the mains plug out of
the mains socket. Keep the mains lead
away from heat, oil, sharp edges or