Parkside PFBS 10.8 A1 - Manual (Page 51)

51 GB
General safety advice for electrical power tools General safety advice for electrical power tools
the device. Many accidents have their origins
in poorly maintained electrical power tools.
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
5. Use and handling of the cord-
less electrical power tool
a) Charge a rechargeable battery unit
using only the charger recommended
by the manufacturer. Chargers are often
designed for a particular type of rechargeable
battery unit. There is the danger of fire if other
types of rechargeable battery units are used.
b) Only the rechargeable battery units
supplied are to be used with an elec-
trical power tool. The use of other recharge-
able battery units may lead to the danger of
injury or fire.
c) When they are not being used, store
rechargeable battery units away from
paperclips, coins, keys. nails, screws
or other small metal objects that could
cause the contacts to be bridged. Short-
circuiting the contacts of a rechargeable battery
unit may result in heat damage or fire.
d) Fluids may leak out of rechargeable
battery units if they are misused. If this
happens, avoid contact with the fluid.
If contact occurs, flush the affected area
with water. Seek additional medical
help if any of the fluid gets into your
eyes. Escaping battery fluid may cause skin
irritation or burns.
CAUTION! DANGER OF EXPLOSION!
The batteries must never be recharged!
6. Service
a) Have your device repaired at the ser-
vice centre or by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
Safety instructions for all
operations
Safety warnings common for grinding,
sanding, wire brushing, polishing, carving
or abrasive cutting-off operations:
a)
This power tool is intended to function
as a grinder, sander, wire brush, pol-
isher, carving or cut-off tool. Read all
safety warnings, instructions, illustra-
tions and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and / or serious injury.
b) Do not use accessories which are not
specifically designed and recommend-
ed by the tool manufacturer. Just because
the accessory can be attached to your power
tool, it does not assure safe operation.
c) The rated speed of the grinding acces-
sories must be at least equal to the max-
imum speed marked on the power tool.
Grinding accessories running faster than their
rated speed can break and fly apart.
d) The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool. In-
correctly sized accessories cannot be adequately
controlled.
e) The arbour size of wheels, sanding
drums or any other accessory must
properly fit the spindle or collet of the
power tool. Accessories that do not match
the mounting hardware of the power tool will
run out of balance, vibrate excessively and may
cause loss of control.
f) Mandrel mounted wheels, sanding
drums, cutters or other accessories
must be fully inserted into the collet