Parkside PEXS 270 A1 - Manual (Page 30)

30 GB/MT
Random orbital sander PEXS 270 A1
Q
Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.
Q
Intended utilisation
The device is intended for dry-sanding wood, metal
and paint. Any other uses, and modifications to the
appliance, are deemed to be improper usage and
may result in serious physical injury. The manufac-
turer will not accept liability for loss or damage
arising from improper use. This appliance is not in-
tended for commercial applications.
Q
Features and Fittings
1 ON / OFF switch
2 Locking button
3 Dust collector
4 Backing pad
5 Grinding disc
6 Exhaust nozzle
7 Adapter for external exhaust suction
8 Reducing piece
Q
Items supplied
1 random orbital sander PEXS 270 A1
1 dust collector
1 grinding disc
1 adapter for external exhaust suction
1 reducing piece
1 set of operating instructions
Q
Technical data
Rated voltage: 230 V∼ 50 Hz
Rated power: 270 W
Idling oscillation
frequency: n
0
24000 min -1
Idling speed: n
0
12000 min -1
Sanding plate: ø 125 mm
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level: 80 dB(A)
Sound power level: 91 dB(A)
Uncertainty K:
3 dB
Wear ear protection!
Vibration total values determined according to
EN 60745:
Vibration emission value a
h
= 6.8 m / s 2 ,
Uncertainty K = 1.5 m / s 2 .
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Introduction