Parkside PABK 60 A1 - Manual (Page 41)

41 GB
… / Cleaning and care / Information about warranty and service processing
Using the accessories (see Ill. D)
Air mattress adapter 6 , Ball needle 12
Use a pipe wrench to unscrew the nozzle 9a
of the blow-out gun 9 .
Then – depending on what is needed – screw
on the air mattress adapter 6 or the ball nee-
dle 12 , as well as the thread adapter 7 into
the barrel of the air blow gun 9 .
Universal valve connection 10
Screw the universal valve adapter (suitable for
tyres, e.g. bicycle tyres)
10 directly onto the air
hose 8 .
Cleaning and care
Thoroughly clean the spray stylus 3 immedi-
ately after use. Otherwise the paint can dry and
cause problems during the next use.
Thoroughly rinse out the spray stylus 3 with
water.
Use the thinner included to clean any stubborn
dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.
Fault Interrupted paint jet
or intermittent paint
delivery
Cause Solution
1. Paint almost
empty
1. Fill paint
2. Paint too viscous 2. Lower viscosity
3. Dry / defective
nozzle
3. Screw in nozzle tightly
or replace
4. Paint supply
restricted
4. Cleaning
Fault Interrupted paint jet
or intermittent paint
delivery
Cause Solution
5. Incorrect posi-
tion of spray
stylus 3 .
5. Correct position angle
Fault Spray pattern
incomplete
Cause Solution
1. Air head
dirty / defective
1. Clean / replace air head
1. Rinse with clear water
2. Nozzle dirty /
defective
2. Clean / replace air
nozzle
Fault Spray pattern irregu-
lar with drips
Cause Solution
1. Defective nozzle 1. Replace nozzle. Contact
a respective service centre.
2. Paint too viscous 2. Lower viscosity
3. Insufficient
working pres-
sure
3. Increase working pres-
sure (if necessary, not in-
cluded accessories, e.g.
pressure reducer)
3. Hose defective; replace
hose
Fault Non-uniform paint
amount delivered
Cause Solution
Nozzle dirty /
defective
Clean / replace air nozzle
Information about warranty
and service processing
Creative Marketing Consulting GmbH
warranty
Dear customer, the warranty for this device is 3 years
from the date of purchase. In the event the product
Preparations for use
96759_par_Airbrush_Set_Content_CH.indd 41 28.04.14 09:11