Parkside PBH 1500 A1 - Manual (Page 22)

19 PBH 1500 A1
GB
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Main handle
Hammer drilling in
Concrete: a
h(HD)
= 10.428 m/s 2 , K = 1.5 m/s 2
Additional handle
Hammer drilling in
Concrete: a
h(HD)
= 8.15 m/s 2 , K = 1.5 m/s 2
Main handle
Chiselling: a
h(CHeq)
= 15.014 m/s 2 , K = 1.5 m/s 2
Additional handle
Chiselling: a
h(CHeq)
= 11.201 m/s 2 , K = 1.5 m/s 2
WARNING!
► The vibration level specifi ed in these instruc-
tions has been measured in accableance
with the standardised measuring procedure
specifi ed in EN 60745 and can be used to
make equipment comparisons. The declared
vibration total value may also be used in a
preliminary assessement of exposure.
The vibration level varies in accableance
with the use of the tool and may be higher
than the value specifi ed in these instructions
in some cases. It is easy to underestimate the
vibration load if the electrical power tool is
used regularly in this manner.
NOTE
► For an accurate estimate of the vibration load
during a certain working period, the times
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
signifi cantly reduce the vibration load over
the total working period.
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fi re and/or serious
injury.
Save all warnings and instructions for future
reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. Work area safety
a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of fl am-
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2. Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodifi ed plugs and matching
outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or ground-
ed surfaces, such as pipes, radiators, ranges
and refrigerators. There is an increased risk
of electric shock if your body is earthed or
grounded.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of electric shock.
IB_35391_PBH1500A1_LB2.indb 19 IB_35391_PBH1500A1_LB2.indb 19 28.05.14 16:36 28.05.14 16:36