General safety notices – Parkside PDSP 1000 B2 User Manual
Page 7
3
PDSP 1000 B2
GB
WARNING!
►
The vibration level specifi ed in these instruc-
tions has been measured in accordance with
the standardised measuring procedure speci-
fi ed in EN ISO 28927 and can be used to
make equipment comparisons. The specifi ed
vibration emission value can also be used to
make an initial exposure estimate.
The vibration level varies in accordance with
the use of the compressed air tool and may
be higher than the value specifi ed in these
instructions in some cases. It is easy to under-
estimate the vibration load if the compressed
air tool is used regularly in a certain manner.
NOTE
►
For an accurate estimate of the vibration load
during a certain working period, the times
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration. This can
signifi cantly reduce the vibration load over
the total working period.
General safety notices
WARNING!
►
Read all safety warnings and all instructions.
Failure to follow the warnings and may result
in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference!
Workplace safety
a) Keep your working area clean and well lit.
Cluttered and dark areas invite accidents.
b) Do not operate tools in explosive atmospheres,
such as in the presence of fl ammable liquids,
gases or dust. Tools can create sparks which
may ignite the dust or fumes.
c)
Keep children and bystanders away while
operating a tool. Distractions can cause you
to lose control.
Device-specifi c safety instructions for
compressed air sandblasters
■
Check the appliance for any possible defects
before use. If the appliance exhibits any faults,
it should not be used under any circum-
stances.
■
Keep children and bystanders away while
operating the tool. Distractions can cause
you to lose control.
■
RISK OF INJURY! MISUSE! Do not point the
tool towards people or animals!
■
Wear a dust mask.
■
Wear safety goggles!
■
Wear protective gloves!
■
RISK OF EXPLOSION! The compressed air
sandblaster gun should not be used in areas
with gas/open fl ames/fi re/gas-operated
water heaters.
■
SMOKING PROHIBITED!
■
Work only in suffi ciently ventilated rooms.
■
Do not use oxygen or any combustible gas
as an energy source.
■
Never exceed the maximum operating pres-
sure of 6.3 bar.
WARNING!
►
KICKBACK FORCES! At high working pres-
sures, kickback can occur which can, under
certain circumstances, lead to danger due to
continuous loads.
■
RISK OF INJURY! Disconnect the appliance
from the compressed air source before starting
any repairs or maintenance work and before
transportation.
■
RISK OF INJURY! Disconnect the appliance
from the compressed air source before refi lling
the blasting medium.
NOTE
►
Please heed the safety instructions provided
by the manufacturer of the blasting medium.
IB_43089_PDSP1000B2_LB4.indb 3
IB_43089_PDSP1000B2_LB4.indb 3
28.05.14 09:04
28.05.14 09:04