Parkside PDBS 6.2 A1 - Manual (Page 42)

42 GB/MT
Introduction
Air metal shears PDBS 6.2 A1
Introduction
Congratulations!
You have chosen high-quality device
by our company. Familiarise yourself
with the product before using it for the first time. In
addition, please carefully refer to the operating instruc-
tions and the safety advice below. Initial operation of
this tool must be performed by trained personnel.
KEEP OUT OF THE REACH OF CHILDREN!
Intended use
The metal shears are an air-powered tool for hand-
yman use. It is designed to cut sheet metal. The user
should wear safety goggles and gloves to protect
himself from accidental contact with potentially sharp
edges. Keep these instructions in a safe place. When
passing this product on to others, please also include
all the documents. Any use other than the intended
is prohibited and potentially dangerous. Damages
resulting from noncompliance or misuse are not cov-
ered by the warranty and are not included in the man-
ufacturer‘s liability. This device has been designed
for household use and may not be used for commer-
cial or industrial purposes.
Features
Check that all the items are present and
that the product is in perfect condition
immediately after unpacking. Never use
the product if it is defective.
1 Plug nipple for compressed air connection
2 Trigger
3 Knife
Technical Data
Max. working pressure: 6.2 bar
cuts aluminium sheets up to 2.4 mm
cuts sheet metal up to 1.1 mm
Weight:
1220 g
Noise and vibration
ATTENTION!
Always wear hearing protection!
The following pictograms are used in these operating instructions / on the equipment:
Please read the operating instructions!
Never use hydrogen, oxygen, carbon
dioxide or other bottled gases as an
energy source.
Note
Wear ear protection, dust mask, safety
glasses and protective gloves.
Observe the warning and safety in-
structions!
Compressed air hose
Caution! Explosion hazard!
Dispose of packaging and device in
an environmentally-friendly way!
Oil daily
Introduction / General safety rules
43096_par_Druckluft-Blechschere PDBS 6.2A1_content_ES_IT_PT.indd 42 28.05.14 16:59