Commissioning, Adjusting the compressed air, Adjusting the torque – Parkside PDSS 310 A1 User Manual

Page 54: Initial use, Changing rotation, Correctly holding the equipment

54 GB/MT

Commissioning

First wrap a piece of Teflon tape (not included)

around the outer threads of the plug nipple

and the lubricator

(see fig. B).

Now screw the plug nipple

into the thread

of the lubricator

(see Figure C).

Tighten this connection with moderate force

and absolutely using pliers.

Now turn the combination of lubricator

and

plug nipple

into the connection thread

of the impact driver (see Fig. C).

Also retighten this connection with pliers.
Now press the air hose onto the plug nipple

using a little force, until the hose locks in.

ATTENTION! Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents

a major hazard. Also ensure the two screw
connections between lubricator

, coupling

and machine are securely seated.

Adjusting the compressed air

Note: this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.

Only use filtered, lubricated and regulated
compressed air.

Adjusting the torque

Set the torque control

to the correct torque

by pressing it toward the housing and turning it
until it locks at the desired setting.

Be sure the operating pressure of the compres-

sor is between 5 and 6.3 bar.

Note: the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.

Setting

(low, min.)

(normal)

(high)

(extra high,
max.)

Initial use

Activate the trigger

to start the equipment.

Release the trigger

to deactivate the equip-

ment.

Changing rotation

ATTENTION! The device must come to a
complete standstill before changing the direc-
tion of rotation.

ATTENTION! A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note: The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch

to change the direction of the impact driver.

Pull the bolt forward in the direction of the „F“
marking („Forward / Fasten“) for clockwise
operation. You can now e.g. tighten screws.

Push the bolt back towards the „R“ marking

(„Reverse / Release“) so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.

Correctly holding the

equipment

This equipment weighs 2.3 kg.

Hold the equipment with both hands to ensure
safe operation (see Fig. D and E).

After initial use / Maintenance / Cleaning and Care / Troubleshooting

96878_par_Druckluft-Schlagschrauber PDSS 310 A1_content_ES_IT_PT.indd 54

23.04.14 15:54