Parkside PMGS 12 B2 - Manual (Page 36)

36 GB
Operation General power tool safety warnings / Operation
b) Use a guard, if recommended, but
make sure that the wire brush does
not come into contact with the guard.
The diameters of disc brushes and cup brushes
can increase due to contact pressure and cen-
tripetal forces.
Q
Device-specific safety instructions
for small drill PMGS 12 B2 and
mains adapter-PMGS 12 B2-1
When you use the drill / grinder wear
the following protective equipment:
safety glasses and protective gloves.
For indoor use only!
CAUTION! The tool continues to rotate
after it has been switched off! Avoid
contact with rapidly rotating drill / grinder com-
ponents.
Securely support the
workpiece. Use clamps or a vice to grip the
workpiece firmly. This is much safer than holding
it in your hand.
Never support your-
self by placing your hands near or in
front of the device or the workpiece
surface. A slip can result in injury.
Avoid contact with moving sanding or
grinding tools.
DANGER OF FIRE FROM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
DUST HAZARD! Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
NOXIOUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Avoid abrading paints containing lead
or other substances hazardous to health.
Do not machine materials containing
asbestos. Asbestos is a known carcinogen.
Do not machine moist materials or
damp surfaces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off
and allow it to come to a standstill be-
fore you put it down.
Always keep the device
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.
Q
Operation
Never use the device for a purpose
for which it was not intended or with
non-original parts / accessories. The use
of tools or accessories other than those recom-
mended in the operating instructions could lead
to you suffering an injury.
Q
Inserting or replacing
a tool / collet
Press the spindle lock 7 and keep it pressed.
Rotate the clamping nut 5 until the lock
engages.
Loosen the clamping nut 5 with the combina-
tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use though the
clamping nut
5 before you insert it into the
collet 18 suitable for the tool shaft.
Press the spindle lock 7 and keep it pressed.