Parkside PWS 125 B2 - Manual (Page 70)

70
GB MT
Practical tips
Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel
for cutting !
Only certified, fibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.
Assembly
Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device
Mount handgrip
The device must only be
operated with the handgrip
mounted.
Screw the handgrip (1), depending on the
type of work, to the left, right or above the
device using the threading for the hand-
grip (2/6)..
Assemble/set protective
hood
The device must only be
operated with the protective
hood mounted.
1. Open the tightening lever
( C 16)
2. Place the protective hood (
11) on the positioning holes.
3. Turn the protective hood (
11) into the working position.
The closed side of the protective
hood must always face the ope-
rator.
4. Close the tightening lever
( C 16) again. The protective
hood should not be able to be
turned any more.
If needed, the tension on the adjustment
nut ( C 1 5) can be set. Use the chuck key
( 9) for this.
Installing/changing disc
1. Press the spindle stop button
( 7).
2. Release the clamping nut
( B 13) with the chuck key
( 9).