Parkside PWS 125 B2 - Manual (Page 65)

65
MT GB
affect the power tool’s operation.
If damaged, have the power tool
repaired before use. Many accidents
are caused by poorly maintained power
tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less Iikely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations diffe-
rent from those intended could result in a
hazardous situation.
Service:
• Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the pow-
er tool is maintained.
Safety instructions for all ap-
plications
Common safety instructions for
grinding, sanding, working with
wire brushes and cutting grinders:
• This electric tool is to be used as
a grinder, sander, wire brush
and cutting grinder. Follow all
safety instructions, directives,
illustrations and facts which you
receive with the device. If you do
not follow these instructions, an elec-
trical shock, fire and/or serious injury
may occur.
• This electric tool is not suitable
for polishing. Using the electric tool
in ways for which it is not intended may
cause hazards and injuries.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed of
the attachment tools must be at
least as high as the highest rota-
tion speed indicated on the elec-
tric tool. Accessories that run faster
than the allowable speed can break and
fly apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool. At-
tachment tools which are wrongly dimen-
sioned cannot be sufficiently shielded or
controlled.
• Attachment tools with threaded
attachment must fit the threading
of the grinding spindle exact-
ly. For attachment tools which
are mounted through a flange,
the diameter of the hole in the
attachment tool must fit the
mounting diameter of the flange.
Attachment tools which cannot be pre-
cisely attached to the electric tool turn
unevenly, vibrate very strongly and can
ultimately lead to a loss of control.
• Never use damaged attach-
ment tools. Check attachment
tools such as grinding discs for
chipping or cracks, grinding pla-
tes for cracks, wear or strong
abrasion and wire brushes for
loose or broken wires before
using them. If the electric tool
or the attachment tool falls off,