Parkside PLEM 50 A1 - Manual (Page 20)

17 PLEM 50 A1
GB
Clear button
♦ By briefl y pressing the
C
OFF
button you can reset the most
recent action.
♦ Repeatedly pressing the
C
OFF
button will delete the content of
the display in the following order: .
Belt pouch
Use the supplied belt pouch to protect the device when not in use.
Faults
If a measurement or a result is faulty, this is indicated by "Er nnn"
in the display and a long beep. The possible causes for this are:
Faults Possible cause Rectifi cation
101 Batteries are weak Replace the batteries
104 Calculation error Repeat the process
152
Operating tempera-
ture too high
Please note the correct operating
temperature
153
Operating tempera-
ture too low
154
Measurement out-
side the measure-
ment range
Keep within the maximum measur-
ing range of the device
155
Received signal too
weak
Avoid non-refl ective or poorly
refl ecting surfaces
Find a measurement point that is
more refl ective
IB_100719_PLEM50A1_LB4.indb 17 28.08.14 11:01