Parkside PHD 100 C2 - Manual (Page 47)

47
GB
E Fixing the Wheels
The back wheels on the chassis (9) can be
ixed in order to secure the pressure wash-
er against undesired rolling away.
• To do this push the two bolts (16) out-
wards and downwards.
The wheels are now no longer able to
turn.
• To cancel the wheel ixing, push the
two bolts (16) upwards.
F Removing the Chassis
The pressure washer can also be used
without the chassis (9).
• Press the release button (18) on the
front locking point. Hold the chassis (9)
securely in the front area and pull the
pressure washer upwards.
At the same time, tilt the pressure
washer slightly to the rear.
• To reinstate, insert the device into the
rear area of the chassis (9). Push down
on the device down and press the re-
lease button (18) at the same time. The
device clicks into the chassis.
Cleaning and Mainte-
nance
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
Cleaning
Never direct the water jet
against the washer, nor clean
the washer under lowing
water. This could give rise to
the danger of electric shock
and damage the washer! .
Always keep the washer clean. Do
not use any detergents or solvents.
• Always keep the ventilation slots clean
and free.
• Only clean the pressure washer with a
soft brush or a slightly moist cloth.
• In case a nozzle of the jet tube
(12/13) is clogged up, use the nozzle
cleaning pin (15) to remove the object
from the nozzle.
G
If necessary, take off the water con-
nection with the ilter insert (8) and
clean the ilter insert.
Maintenance
The pressure washer is maintenance free.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
Storage
• Drain all the water from the pressure
washer. Disconnect the unit from the
water supply. Press the On/Off switch
(
A 5) to turn on the pressure washer
for no longer than 1 minute until no
more water escapes from the high-
pressure connection (
A 5). Turn off the
unit.