Parkside PBH 440 A1 - Manual (Page 25)

22 PBH 440 A1
GB
Operation
Selecting a function using the function
selector switch
♦ Press and hold the unlocking button for func-
tion selector switch and rotate the function
selector switch so that the required symbol
engages at the arrow mark.
The functions are marked as follows:
Function Symbol
Drilling / screwdriving
Hammer drilling
Chiselling
Chisel position
adjustment
Adjust chisel position:
You can rotate the tool to the required position for
chiselling using this function.
♦ Rotate the function selector switch to
position .
♦ Rotate the tool into the tool holder to the
required position.
♦ Rotate the function selector switch to
position for the chiselling function.
Select direction of rotation
♦ Select the direction of rotation by adjusting the
right/left rotation switch .
WARNING!
► The right/left running switch may only
be used / adjusted if the appliance is at a
standstill.
Switching on and off
Switching the appliance on:
♦ Press the ON/OFF switch .
Switching the appliance off :
♦ Release the ON/OFF switch .
Switching to continuous operation:
♦ Press the ON/OFF switch and lock it in
this position with the ON/OFF switch locking
button .
Switching off continuous operation:
♦ Press the ON/OFF switch and release it
again.
Maintenance and Cleaning
WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work.
■ The appliance must always be clean, dry and
free from oil or grease.
■ To clean the casing, use a soft cloth.
■ Regularly clean the tool holder .
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or his representative in order to avoid hazard-
ous situations.